High quality anti-corrosion and anti-gravel agent in the form of a liquid based on synthetic resins and rubbers
It is intended for processing of external and internal surfaces of a car body, a bottom, wheel arches, wings, aprons, lower surfaces of thresholds of cars, etc
It is suitable for processing the internal surfaces of the hood, doors, and body amplifiers
For professional body repairs, it is used to protect welds from inside of panels, protect the internal surfaces of new body panels, as well as to process fenders, doors, aprons, hoods, trunks, etc. before installing on the car
Properties:
Reliably protects the body from the negative effects of road salt and deicing reagents, all types of atmospheric effects, corrosion, protects from scratches caused by road surface particles (gravel, crushed stone, etc.)
Has passivation properties, significantly slowing down the corrosion process that has already begun
Forms a strong, smooth, indelible elastic film with ticostropic properties (can be applied in a thick layer without forming smudges and self-leveling, and scratches on it are prone to self-tightening), resistant to mechanical influences, to moisture, salts, acids and alkalis after drying
Does not chip or wear during operation
Effectively penetrates into the smallest crevices, displacing water from cracks, crevices and joints between the body panels, forms a waterproof layer
Has excellent adhesion – holds securely even on smooth, non-porous surfaces
It does not lose its adhesive properties at extremely high temperatures – it does not peel off and is securely held on a heated surface
Neutral to metals, plastics, rubbers and paint coatings
Resistant to extremely low temperatures, retains plasticity and does not crack
It has sound-proof and anti-vibration properties, significantly reducing road noise and vibrations of body elements, thereby increasing the comfort of driving
Dry quickly
The declared properties are acquired after complete drying
Application: before applying the product, the surface must be thoroughly cleaned of rust, dirt and dust, grease, oil and other organic contaminants. For degreasing, we recommend using brake Cleaner
For best results, it is recommended to apply the product at room temperature
The product is applied using a spray gun with a compressor at a pressure of 2 to 8 bar (depending on the desired fineness of the spray)
Shake the balloon well before use. After pouring the product into the spray container, immediately close the balloon, as a film forms very quickly on the surface of the product
Spray with a layer of up to 1.5 mm at a distance of about 20-30 cm from the surface
Resistance to abrasion and corrosion increases with the thickness of the coating
For this reason, the spray process should be repeated once or twice after a short (1-2 minutes) drying time
To obtain a uniform coating and not to leave untreated areas, the spray must be carried out crosswise
The coating is not subject to further staining
Depending on the thickness of the layer and weather conditions, the car is ready to move again in about 2 hours
Final drying takes 12-24 hours
|
